New update Lead4Pass NSE7_SDW-6.4 Dumps with PDF and VCE| Fortinet NSE 7 – SD-WAN 6.4 Exam
New updated leads4pass NSE7_SDW-6.4 Dumps with PDF file and VCE practice exam engine to help pass the Fortinet NSE 7 – SD-WAN 6.4 Exam successfully!
leads4pass NSE7_SDW-6.4 exam dumps contain 80 exam questions and answers, covering complete Fortinet NSE 7 – SD-WAN 6.4 certification exam questions, and verified to be true and valid, check here to get the latest leads4pass NSE7_SDW-6.4 dumps: https://www.leads4pass.com/nse7_sdw-6-4.html (PDF+VCE).
Check out the NSE7_SDW-6.4 PDF exam questions and answers shared for free: https://drive.google.com/file/d/1dpLCcglwOgNbQxSRXC6bByoDToaMtkqP/
Also, read the latest 15 leads4pass NSE7_SDW-6.4 exam questions and answers online:
Question 1:
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups and site-to-site between Hub 1 and Hub 2. The administrator configured ADVPN on the topology of the dual region.
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two.)
A. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
B. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
C. London generates an IKE information message that contains the Toronto public IP address.
D. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
Correct Answer: AD
Reference: https://docs.fortinet.com/document/fortigate/6.0.0/handbook/320160/example-advpnconfiguration
Question 2:
Refer to exhibits.
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
FortiGate is not performing traffic shaping as expected, based on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which
policy?
A. The URL category must be specified on the traffic shaping policy.
B. The shaper mode must be applied per-IP shaper on the traffic shaping policy.
C. The web filter profile must be enabled on the firewall policy.
D. The application control profile must be enabled on the firewall policy.
Correct Answer: C
Question 3:
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
A. The 10 Mbps bandwidth is shared equally among the IP addresses.
B. Each IP is guaranteed a minimum 10 Mbps of bandwidth.
C. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
D. A single user uses the allocated bandwidth divided by total number of users.
Correct Answer: C
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
Question 4:
Which three parameters are available to configure SD-WAN rules? (Choose three.)
A. Application signatures
B. Incoming interface
C. Internet service database (ISDB) address object
D. Source and destination IP address
E. Type of physical link connection
Correct Answer: CDE
Question 5:
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
A. diagnose sys virtual-wan-link health-check
B. diagnose sys virtual-wan-link log
C. diagnose sys virtual-wan-link sla-log
D. diagnose sys virtual-wan-link intf-sla-log
Correct Answer: C
Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
Question 6:
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
A. diagnose sys virtual-wan-link route-tag-list.
B. diagnose sys virtual-wan-link service.
C. diagnose sys virtual-wan-link member.
D. diagnose sys virtual-wan-link neighbor.
Correct Answer: C
Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/818746/sd-wan-related-diagnosecommands
Question 7:
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output. Based on the exhibits, which statement is correct?
A. Port1 became dead because no traffic was offload through the egress of port1.
B. SD-WAN member interfaces are affected by the SLA state of the inactive interface.
C. Both SD-WAN member interfaces have used separate SLA targets.
D. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
Correct Answer: D
Question 8:
Which statement is correct about the SD-WAN and ADVPN?
A. Spoke support dynamic VPN as a static interface.
B. Dynamic VPN is not supported as an SD-WAN interface.
C. ADVPN interface can be a member of SD-WAN interface.
D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Correct Answer: C
Question 9:
Which two reasons make forward error correction (FEC) ideal to enable in a phase one VPN interface?
(Choose two.)
A. FEC is useful to increase speed at which traffic is routed through IPsec tunnels.
B. FEC transmits the original payload in full to recover the error in transmission.
C. FEC transmits additional packets as redundant data to the remote device.
D. FEC improves reliability, which overcomes adverse WAN conditions such as noisy links.
E. FEC reduces the stress on the remote device jitter buffer to reconstruct packet loss.
Correct Answer: CD
Question 10:
Refer to exhibits.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
A. All the existing sessions that do not use SNAT will be flushed and routed through port1.
B. All the existing sessions will continue to use port2, and new sessions will use port1.
C. All the existing sessions using SNAT will be flushed and routed through port1.
D. All the existing sessions will be blocked from using port1 and port2.
Correct Answer: BC
Question 11:
Which components make up the secure SD-WAN solution?
A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
B. Application, antivirus, and URL, and SSL inspection
C. Datacenter, branch offices, and public cloud
D. Telephone, ISDN, and telecom network
Correct Answer: A
Question 12:
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? (Choose two.)
A. There are separate virtual interfaces for each dial-up client.
B. VPN static routes are prevented from populating the FortiGate routing table.
C. FortiGate created a single IPsec virtual interface that is shared by all clients.
D. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
Correct Answer: CD
Question 13:
Refer to exhibits.
Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)
A. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
B. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.
C. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces.
D. The initial session of an application goes through a learning phase in order to apply the correct rule.
Correct Answer: AB
Question 14:
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two.)
A. Specify outgoing interface routing cost.
B. Configure SD-WAN rules interface preference.
C. Select SD-WAN balancing strategy.
D. Specify incoming interfaces in SD-WAN rules.
Correct Answer: AB
Question 15:
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
B. Changes have been made on firewall policy ID 1 on FortiGate.
C. Firewall policy ID 1 has source NAT disabled.
D. FortiGate has terminated the session after a change on policy ID 1.
Correct Answer: B
…
Latest Complete 80 NSE7_SDW-6.4 Certification Exam Questions With Answers Get leads4pass NSE7_SDW-6.4 Exam Dumps: https://www.leads4pass.com/nse7_sdw-6-4.html (PDF+VCE)
